The video reference below contains instructions for changing the engineering units on a Despatch Protocol 3 oven controller.
ITW EAE Support Center
Related Articles
- Protocol3 Profile & Configuration Backup
- Protocol3 Relay Output Set Up
- Protocol3 Reset to Default
- Protocol3 Calibration Offset
- Protocol3 Temperature Units Change
- Protocol3 Recorder Function
- L91 Calibration
- Setting the Configuration for the DES 2000 Controls
- Changing Units from Centigrate to Fahrenheit on the DES 2000 Controller
- Fan Motor Replacement in LBB Ovens
- Replacing a Heater in a Despatch Lab Oven
- DES2000 Change Engineering Units
- Airflow Switch Test
- Protocol3 Automatic Start
- Protocol3 Engineering Units
- How to Assembly a Despatch Oven Stand
- Purge timer replacement
- Protocol3 Controller Profile Set Up
- Replacing a Protocol with a Protocol 3 Controller
- Replacing the Protocol Plus with the Protocol 3 Controller
- LBB DES2000 Control & L91 High Limit Parameters
- Protocol Manager Setup
- Protocol Plus Profile Programming
- Partlow 1462 Profile Programming
- Protocol3 PID and Control Configuration
- FDC9100 Control Setup
- DES2000 Calibration
- H5CX-N Timer Programming
- L91 Hi-Limit Setup