The attached instructions explain how to change the MAC valve that controls the tank pressure to a SMC valve on Servojet, ServoSonic and ServoSpray fluxers. This will need to happen if the MAC valve fails.
ITW EAE Support Center
Related Articles
- Wet Section Exhaust Set Up - Aquastorm
- AQUASTORM Torrid Zone Exhaust Adjustment
- How to Clean the Actuator on a Fluxer
- Pre-Installation Instructions - EVT Reflow Equipment
- Pre-Installation Instructions - EVT Cleaner Equipment
- Pre-Installation Instructions - EVT Wave Equipment
- Aquastorm Pressure Transducer Calibration
- Aquastorm Pump Seal Damage When Your Pump Runs Dry
- Uninterruptible Power Supply Advanced Menu Adjustments
- Aquastorm Automatic Chemical Dosing Setup
- Effluent Management and The Aquastorm 50
- Aquastorm 100 with Chemical Isolation Cascade Setup Options
- Aquastorm 200 Cascade Setup Options
- Aquastorm Bath Maintenance and Change Out
- OmniMax / OmniES Blower Life Span
- AVR2560 Retrofit Instructions for ServoSpray, ServoSonic, and Servojet Fluxers
- Calculating Required Wattage for Inline Water Heaters
- Aquajet Batch Cleaner Obsolete
- How To Reset Supervisor Password if Changed For OmniExcel Machine
- Wave Diffuser Cleaning Procedure