For Windows 10, the .NET 2.0 needs to be enabled/installed manually.
See this link. There are two different ways to install the .NET 3.5 (2.0) framework.
https://docs.microsoft.com/en-us/dotnet/framework/install/dotnet-35-windows-10
ITW EAE Support Center
Related Articles
- How do I change the setpoint on a 1161+ high limit?
- What Affects Temperature Uniformity
- How Do I Test My Airflow Switch
- What preventative maintenance measures do you recommend on my oven?
- How does the LCC/LCD water cooling system work
- What is a Class A Oven?
- How do I set up Protocol3 Ethernet Communications
- How do I contact Despatch Tech Support?
- How do I convert from a DES2000 to a FDC9100 control?
- Where do I find my new oven manual
- How do I weld my heater leads to the buss bars?
- How do I wire my standard 3 phase heater?
- Why won't my Protocol3 Ethernet Setup tool software run
- How do I set my oven dampers?
- Equipment Installation Clearances Despatch
- Why won't my USB memory drive work with the Protocol3
- Where is the serial number on my Despatch oven located?
- How do I identify my LBB door latch part number?
- How do I use my oven manual card?
- How do I set the clock on my Protocol3 control?
- Will my 240 volt oven operate on 208 volt power?
- How do I get a replacement manual or print for my Despatch oven?
- Why does my oven heat up when only the fan is running?
- How do I get support for my Despatch solar oven?
- How do I reset my Protocol Plus Control to factory default?
- What USB Memory drives can I use with a Watlow F4T control?